Publicidad
Idiomas disponibles
Idiomas disponibles
Ref. 7960
PROGRAMMING THE RF RECEIVER
Follow the steps shown in the table below for programming the
transmitters:
1. To program the codes, supply the module with
the jumper J2 into P position.
2. Once the reciever is supplied, the green led
will remain lightening and the red led will flash
(in shorts of 1 second) as many times as codes
programmed in the system (when programming
first time it will not flash).
3. The green led will flash indicating that it is ready
to store new codes (transmitters).
4. Press the button in the transmitter.
5. The red led will flash once to indicate that the
system has recognised the new device.
Switch-off the module and put the jumper J2
back to the position T.
To erase a code, it is necessary to erase the whole memory.
The memory is erase by pressing the door releasing button when
the module is in programming mode.
DIRECT DOOR RELEASE BUTTON
The terminals B and - are used to connect a pushbutton to open
directly the door, which will give exactly the same response from the
system that if a valid code would be received.
8 s.
ACTIVATION TIME
T
1
2
O
P
3
Use the microswitch SW1 to set up the door releasing time (relay
J2
SW
activation), following the diagrams shown below. The filled portion
indicates the switch position.
N
ROG.
8 s.
10 s.
12 s.
14 s.
12 V
T
1
RX
2
ON
P
3
FLIP-FLOP
J2
TX
SW1
ON
ROG.
G.
8 s.
10 s.
12 s.
14 s.
12 V
8 s.
T
1
RX
2
ON
The FLIP-FLOP option is used to keep the contacts closed until the
P
3
J2
TX
SW1
pushbutton in any transmitter is pressed again.
12 V
T
1
RX
2
ON
P
3
J2
TX
SW1
2 s.
4 s.
6 s.
10 s.
12 s.
14 s.
12 V
1
2
3
1
2 3
1
2
3
1
2 3
1
2 3
1
2
3
1
2
3
1
2 3
Publicidad
