Bestway 58397 Manual Del Propietário página 7

1
O-ring
5
1. Use the screwdriver and turn counter clockwise to release the Flange Clamp and remove the Top Tank.
2. Assemble the Collector Hub to the Skimmer by screwing it clockwise.
3. Slowly add the sand so the weight of the sand does not damage the Skimmer, until it reaches between the
marked "MAX" and "MIN". Do not pour the sand into the pipe of the Collector Hub. #20 Silica sand
0.45-0.85mm, approximately 8.5 kg.
4. Ensure the O-ring is in place on the rim of the Bottom Tank. Make sure the O-ring and the rim of the Bottom
Tank are clean without nicks, tears, scraps or sand. Attach the Top Tank; to the Bottom Tank, place the
Flange Clamp over the seam and use the screw driver to fasten it.
5. Attach the Control Valve to the Top Tank, ensuring the O-ring is in place on the rim of the Top Tank. Make
sure the O-ring and the rim of the Top Tank are clean without nicks, tears,scrapes or sand comma and that
the vertical pipe of the Collector Hub is inserted into the base of the Control Valve.
6. Make sure Port C on the Control Valve is aligned with Port C on the Pump.Attach the Top Flange Clamp and
screw into position.
7. Refer to the leaflet in the accessory kit to assemble one adapter to one end of the Piping. Attach the Piping
with the adapter end to Control Valve Port C, screw the threaded locking ring into position. Attach the other
end of the piping to the Pump Port C, secure and tighten the Hose Clamp. Make sure the Washer or O-ring is
properly positioned on both ends of the Piping.
Section II: Hose Configuration for Backwashing and Rinsing
NOTE: Ensure the Control Valve is set to the Closed function.
Your pool should be filled with water, make certain all of the pool 's Debris Screens(26) are fully submerged in
water.
1. Attach one Hose(25) to the sand filter'Port B;make sure the
O-ring(8) is properly positioned, secure and tighten the Hose
Clamp(9).
2. Connect the other end of the Hose(25) to the pool's Outlet "B".
3. Remove the Stopper Plug from the pool's Outlet B and insert
Debris Screen(26) supplied with your kit.
4. With the Hose and the Debris Screen in position, secure and
tighten the Hose Clamp.
NOTE: It is important to ensure all elements: Hose, Debris Screen
and pool outlet are aligned properly
• Screw the other Hose to Port D (refer to the leaflet in the accessory kit to assemble the adapters); and place
the opposite end in drain area.
• With the Hoses attached, you can proceed to fill the pool, refer to pool owner's manual for filling instructions.
2
C
C
6
MAX
MIN
3
C
C
7
7
O-ring
4
9
9
25
Liner
Liner
S-S-003420