Digital Effect Engine - Phonic IMPACT 8.4 Manual Del Usuario

DIGITAL EFFECT ENGINE

The following refers to Impact X models only.
32. Program Control
This control is used to scroll through the various effects
shown on the Digital Effect Display. Turning the control
will automatically change the effect and apply it to the
mix. For a full list of available programs and their pa-
rameters, please check the Digital Effect Table.
33. Peak Indicator
This LED indicator will illuminate when the EFX signal
hits high peaks, 6 dB before overload occurs. It is best
to adjust the EFX Return fader so as to allow the Peak
indicator to light up on high peaks only. This will ensure
a greater dynamic range for audio.
34. Parameter Control
This will adjust the appropriate parameter of the digital
effect that is applied to the audio feed. Please refer to
the Digital Effects Table for more information on effect
parameters.
35. Tap Delay Button and Indicator
When the tap delay effect is selected, pushing this but-
ton twice will allow the processor to calculate the time
between the two pushes and use this as the tap delay
time. If the button is pushed multiple times, the proces-
sor will calculate the time between the last two pushes
only. The LED that accompanies it will flash at the se-
lected interval.
8
35
IMPACT 8.4/12.4/16.4/24.4/8.4X/12.4X/16.4X/24.4X
36. To Aux 1 and 2 Controls
These controls allow users to adjust the signal level
that is being sent from the Effects Engine to the auxil-
iary 1 and 2 mixing buses, the signal of which is suit-
able for connecting stage monitors, allowing artists or
engineers to listen to the music that is being played.
37. Mute Button
This button mutes the EFX channel, effectively stop-
ping the signal processed by the built-in Effects Engine
from being sent to the Main L/R mixing bus.
38. PFL Button
The PFL – or Pre-Fader Listen – button is pushed to
allow the signal of the Effects Engine to be sent to the
CTRL RM / PHONES mix. This allows easier tracking
of audio by sound engineers.
39. DSP Effects Fader
This 60mm fader will alter the signal level that is sent
from the Effects Engine to the Main L/R mix.