ARIETE 1783 Manual De Instrucciones página 13

blade support (D), as illustrated in Fig. 5.
WARNING: Before starting the appliance, make sure that the bowl (U) and the disc (H) are perfectly
clean and without any traces of butter or egg yolk.
- Cut the foods into small pieces (1.5 x 1.5 cm) and place them inside the bowl (U) or for mixing,
insert the ingredients.
- Place the lid (O) onto the bowl (U) and lock it by rotating it clockwise, so that the flap on the lid
perfectly engages in the opening on the bowl handle (Fig. 6).
- Plug the appliance into the mains power.
- Start the appliance, selecting the rotation speed of the blade using the operating dial (A).
The appliance is equipped with a speed scale, from the minimum to the "MAX" one.
WARNING: When using the appliance for mixing or whipping, it is recommended to start at a low
speed and to continue with a higher one. When used to chop, it is advisable to use the pulse func-
tion, turning the dial (A) anticlockwise to the "P" setting. For optimum use, press the button in short
bursts (2/3 sec.).
- For smoother, finer chopped foods, remove the food, if necessary, from the sides of the bowl with
a spatula, pushing it towards the centre.
- If it is necessary to add foods during appliance operation, use the opening in the lid (O). Push the
foods down with the pusher (G) on its own (Fig. 7).
- To stop the appliance, turn the dial (A) to "0".
Slicing
WARNING: The blades are sharp; handle with care.
- Insert the required blade, the slicing blade (M), the julienne blade (L) or the chip cutting blade (N)
onto the blade disc (I) so that the front hole engages on the disc central shaft. Slightly press the
blade on the rear side, until it locks (Fig. 8).
- Mount the complete blade disc (I) onto the motor shaft (C) by taking it from the central shaft, with
the blade upwards (Fig. 9).
- Fit the lid (O) over the bowl (U) and proceed as described in the section "Chopping, mixing or
whisking".
INSTRUCTIONS FOR BLENDER USE
- Fit the blender (Q) onto the power base (B) and turn it clockwise until it clicks into place and so
that the tabs on the blender fit perfectly into the slots in the power base (Fig. 10).
- Fit the lid (R) onto the blender (Q) and press it gently down until fully inserted (Fig. 11).
- Insert food previously prepared through the hole of the cover (R), without exceeding the max. level
indicated on the blender (Q), and then place the cap (P) onto the cover (R), so that the notches of
the cover engages perfectly into the corresponding slots on the cover (Fig. 12).
Note: The plug (P) also has a measure.
- Switch on the appliance, selecting the blade rotation speed with the operating dial (A).
The appliance is equipped with a speed scale, from the minimum to the "MAX" one.
It is also possible to select pulse operation by turning the dial (A) anticlockwise to "P". For the best
use of this function, only turn the dial for a very short time (2-3 sec.).
- 11 -
EN