Ingersoll Rand SRA010A1 Manual De Instrucciones página 3

OPERATION
Make direct cuts into wood or comparable material
as shown in the following illustrations:
1. Hold the saw as shown in Figure 1 with the Saw Guide
firmly against the material and the tip of the Blade
above the material. Press the Trigger.
Figure 1
2. Raise the handle of the Saw, bringing the tip of the
Blade in contact with the material. See Figure 2.
Figure 2
Model
SRA010A1
PLACING TOOL IN SERVICE
3.
4.
HOW TO ORDER A SAW
Length of Stroke
in
5/8
3
Raise the Saw slowly to an upright position, keeping
the Saw Guide firmly against the material. Guide the
Saw in this position along the direction of the cut.
When cutting metal from an edge, hold the Saw as
shown in Figure 3, keeping the Saw Guide firmly
against the work to prevent vibration of the metal and
blade chattering. When making direct cuts into metal,
first chisel or drill a starting hole.
Figure 3
mm
16
(Dwg. TPD1194)
Strokes per minute
1,600