Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (with display)
1.
Enter the on-board programming function either via the tact switches or hall effect
sensor
2.
Enter Nav learn mode. When entered the following pictogram will be represented on
the display.
3.
A 40 second countdown will begin allowing time for you to ensure the elevator is on
the bottom position of the elevator shaft
4.
Once the 40 second countdown is complete the below pictogram will show
prompting the installer to press every floor button available on the COP
5.
Your elevator should now be travelling to each stop available. Once a stop has been
reached the display will show this sequence "Learning Stop X" > "Stay on this stop" >
"Stop Learned" and will continue for however many stops are available
7
Publicidad
Tabla de contenido
