Publicidad
Idiomas disponibles
Idiomas disponibles
(continued)
WIRING: Option 3 – Hardwire Direct to Fixture
STEP 1: Disconnect power from the breaker or fuse box.
STEP 2: Remove the most convenient of 3 knockouts and attach
the provided 3/8" die-cast connector.
STEP 3: Mount the fixture.
Wiring using FRONT COVER, follow steps 4 – 7 below
STEP 4: Open the front panel of the fixture to access the wiring
by using a flat tool to pry open the compartment (A).
STEP 5: Insert the wiring from the power source through the
connector and connect them to the corresponding wiring inside
the fixture (B). BLACK = Hot, WHITE = Neutral, GREEN = Ground.
STEP 6: Ensure excess wires are settled inside the fixture.
STEP 7: Close the front cover.
Wiring using REAR ACCESS, follow steps 4 – 7 below
(only for 63-503 & 63-504)
STEP 4: Remove the rear access panel (C) by loosening
the rear screw.
STEP 5: Insert the wiring from the power source through
the connector and connect them to the corresponding wiring
inside the fixture (B). BLACK = Hot, WHITE = Neutral,
GREEN = Ground.
STEP 6: Ensure excess wires are settled inside the fixture.
STEP 7: Close the rear access panel.
CONNECTING MULTIPLE FIXTURES
Cable
(sold separately)
End-to-End Connector
STEP 1: Remove electrical port covers on the facing ends.
STEP 2: Connect the cable to the OUTPUT of the first fixture
and the INPUT of the next fixture.
Model #
Cable Connector/Length
63-511
63-515
63-516
63-517
63-518
Male to Female Extender
NOTE: Maximum number of connected fixtures is
24 units.
OPERATION
Upon completing the mounting and wiring of this fixture,
power can be restored. This fixture includes a Color Selection
feature and HI / LOW / OFF Dimming.
These fixtures can also be wired directly to an in-wall
dimmer or switch.
For compatibility information, visit www.Satco.com.
© Copyright 2021 Satco Products, Inc. 3/21
(provided)
End-to-End
6 inches
12 inches
24 inches
(A)
(B)
(C)
End-to-End Connector
2
Cable
Satco Products, Inc.
Brentwood, NY 11717
Publicidad
