Electrical Safety; Overview (Fig. A) - Black and Decker KC2000 Manual Del Usuario

Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 4 °C and
40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Under extreme conditions, battery leakage may occur.
When you notice liquid on the battery, proceed as follows:
- Carefully wipe the liquid off using a cloth. Avoid skin
contact.
- In case of skin or eye contact, follow the instructions below.
Warning! The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact, immediately
rinse with water. Neutralise with a mild acid such as lemon
juice or vinegar. In case of eye contact, rinse abundantly with
clean water for at least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a
detached battery (e.g. when storing the battery in a
toolbox).
Do not incinerate the battery.
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge batteries
of the type supplied with your tool. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
Additional safety instructions for drill/screwdrivers
Before drilling into walls, floors or ceilings, check for the
location of wiring and pipes.
Avoid touching the tip of a drill bit just after drilling, as it
may be hot.
Additional safety instructions for jigsaws
Always use the appropriate type of saw blade for the
workpiece material and type of cut.
Only use saw blades in perfect condition.
Always switch the tool off and wait for the saw blade to
come to a complete standstill before putting the tool down.
Keep your hands well clear of the saw blade while working.
Whenever possible, use clamps or a vice to secure the
workpiece.
Additional safety instructions for sanders
Always wear a dust mask whenever sanding.
Thoroughly remove all dust after sanding.
Take special care when sanding paint which is possibly
lead based or when sanding some woods and metal
which may produce toxic dust:
- Wear a dust mask specifically designed for protection
against lead paint dust and fumes and ensure that persons
within or entering the work area are also protected.
- Do not let children or pregnant women enter the work
area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris safely.

Electrical safety

Your charger has been designed for a specific mains voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Your charger is double insulated in accordance with
EN 60335; therefore no earth wire is required.

OVERVIEW (fig. A)

Motor unit
1. Variable speed switch
2. Forward/reverse slider
3. Head release button
4. Bit holder
5. Battery
6. Battery release buttons
Drill/screwdriver head
7. Torque adjustment collar
8. Chuck
Jigsaw head
9. Lock-off button
10. Saw shoe
Sander head
11. Sanding base
Charger
12. Charger
13. Charging indicator
14. End of charge indicator
ENGLISH
5