Tabla de contenido
Publicidad
APRO 20
SETTING FOR OPERATION
The APRO 20 movement detector can be configured in mono direction mode (one
direction only) or in bi directional mode (in both directions).
Remove the rubber plug from the lower section of the detector (Fig. 1-A) and set the
required function through the dip-switch (Fig. 1-B), choosing from the possibilities
indicated in the table:
DSW1 DSW2 DSW4 SENSITIVITY
OFF
-
ON
Low
OFF
-
OFF
High
ON
OFF
ON
Low
ON
OFF
OFF
High
ON
ON
ON
Low
ON
ON
OFF
High
ASSEMBLY AND ORIENTATION
APRO 20 can be installed at the centre of the door to be controlled or on the side, on
non-vibrating structures (walls or ceiling) and at a maximum height of 6 m. Use the
template supplied to prepare the holes.
Fasten the device using the prepared holes, remove the lower cover (Fig. 2-A) and
loosen the screw that blocks the detector orientation. Direct the detector toward the area
to be controlled and lock in that position.
For correct operation, do not install APRO 20 :
- facing the moving parts of the door
- facing fluorescent lights (minimum distance 2m)
- facing areas where rain could provoke water fluxes
These conditions could activate the device and cause the unwanted opening of the door.
ELECTRICAL CONNECTIONS
Connect the pre-wired cable as indicated in table 1 then power the detector.
ENGLISH
CONDITION
Movement is detected in both directions
Movement is detected in both directions
Approach to the sensor is detected
Approach to the sensor is detected
Movement away from the sensor is detected
Movement away from the sensor is detected
APRO 20
Die auf der Vorderseite des Bewegungsmelders vorhandene LED (Abb. 2-B) zeigt
während der gesamten Anzugszeit des Relais die erfolgte Erfassung einer Bewegung
an.
A
E
F B
Abb.1
Drahtfarbe
Beschreibung
Rot
12-24 V
AC/DC
Schwarz
12-24 V
AC/DC
Grün
COM Relaiskontakt
Gelb
Schließer (bei nicht gespeistem Gerät)
Blau
Öffner (bei nicht gespeistem Gerät)
Tab. 1
EINSTELLUNG DES RELAISKONTAKTS
Der Bewegungsmelder APRO 20 verfügt über ein Relais mit Wechsler.
Durch die Einstellung des DIP-Switch 3 (Abb. 1-B) im unteren Bereich des
Bewegungsmelders ist es möglich, die in der Tabelle 2 beschriebenen Kombinationen
zu erhalten.
Diese Bedingungen gelten bei gespeistem Gerät.
DEUTSCH
B
A
Abb.2
Publicidad
Tabla de contenido
