OPERATING ISSUE
Motor will not start.
There is little or no suction.
Red warning light is on.
Vacuum is hard to push.
Front cover will not close.
Vacuum has burning smell.
Dust leaking out of vacuum.
Cannot remove or insert
disposable bag.
PAGE 9 OF 27
TROUBLESHOOTING
CAUSES
Power switch.
Power plug.
Thermal cutoff.
Dust bag and filters.
Air path blocked.
No suction at end of hose.
Carpet height setting.
Brushroll stall, full bag or
blockage.
Carpet height setting.
No dust bag.
Something may be caught in
the brushroll.
Bag is not seated properly.
Front cover latch is in locked
position.
1-800-295-5510
uline.com
RECOMMENDATIONS
Turn power switch on and wait one
minute.
Push plug securely into extension
cord. Press cord into clip to secure the
connection.
Plug extension cord securely into outlet.
Try another outlet.
Check circuit breaker.
See Thermal Cutoff on page 2.
Replace dust bag, clean and/or
change filters.
Remove debris from air path. See
Cleaning Air Path on page 6.
Check hose for blockage. See Clearing
Wand and Hose on page 6.
Adjust knob to lower position. See
Vacuum Cleaner Height Settings on
page 5.
Replace dust bag or clear blockage.
Turn power off to reset. See Changing
Dust Bag on page 7.
Adjust knob to higher position. See
Vacuum Cleaner Height Settings on
page 5.
Install dust bag. See Changing Dust
Bag on page 7.
Check for obstruction and remove.
Ensure bag collar is properly installed in
dust bag housing.
Open latch on front cover. Locate bag
collar and squeeze tabs to remove or
insert disposable bag.
0421 IH-7147