Tool Operation - Bahco BCL33IW1 Manual De Instrucciones

6. While charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in
the room for one hour to warm up before starting the battery pack.
7. R emove the plug after finishing the charge.
8. The charger should be cooled at least one hour after continue charging three times.
9. Do not use generator for charging the battery pack.

8. TOOL OPERATION

Installing Or Removing Socket
Always be sure that the machine is switched off and the battery pack is removed before
installing or removing the socket.
Caution
1. To install the socket, push the socket into the driving spindle as far as it will go. (See Fig. 1).
2. To remove the socket, simply pull the socket from the driving spindle.
3. To start the machine, simply pull the main switch. Machine speed is increase by increasing
pressure on the main switch. Release the main switch to stop.
4. For reversing the machine, (See Fig. 2) use the forward / reverse rod on the drive unit. The
directions of the rotation are also shown on the face of the bar.
5. This model has 2 sections. 1
fully speed power, it will only activate when the torque control knob switch to forward mode.
When need to use fully power, switch the torque control knob to
No-Load Speed
Forward
Max. Torque
6. P lease noted these values are lab. Tested figures and may have variation up to ±15%. The
actual torque output from the tool may change due to different socket tolerance, grease
condition and wheel material.
7. Always check the direction of rotation before operation.
8. Use the forward / reverse rod only after the machine come to a complete stop. Changing
the direction of rotation before the machine stops may damage the machine.
9. H old the machine firmly and place the point of driver socket in the nut.
Apply forward pressure to the machine to the extent that the socket will not slip off the nut
and turn the machine on to start operation.
•
Use the proper socket for the nut that you wish to use.
•
Hold the machine pointed straight at the nut. If you tighten the nut for a time longer than it
needs, the nut or the point of the driver socket may be overstressed, stripped, damaged,
etc. Before starting your job, always perform a test operation to determine the proper
tightening time for your screw. When tightening a standard nut in a steel plate, the proper
tightening torque can be obtained in an extremely short time.
Turn the machine off as soon as the impact sound is heard. When tightening nut M6 or
smaller, carefully adjust pressure on the main switch so that the nut is not damaged.
Fig. 1
st section is pre-tighten function. Pre-tighten means 15% of
550 r.p.m.
1070 kg-cm / 105 N.m /
75 ft-lb
• 9 •
Fig. 2
.
Sections
0~1650 r.p.m.
6000 kg-cm / 590 N.m /
435 ft-lb