Appliance Parts; Fan Assembly - Kasanova FME000005NOC Manual De Instrucciones

STANDING FAN

APPLIANCE PARTS

A- Base
B- Base bracket (over) C base bracket (under) D upright pole
E- Cap
F- Motor/upright pole fastening screws G height adjusting ring nut
H- Motor unit with keypad
L- Pin for swing selection M Rear grid
N- Small hole
O- 2 small cylinders P Ring nut
Q- Blade
R- Motor unit shaft
S- Blade fastening pin
T- Grooves on the back of the blade U Blade fastening back screw plug V Front grid
Z- Small hole
X1- Screw
X2- Nut
Y- Outer closure of the grids W 0-1 - 2 -3 fan intensity keys
Assembling the cross stand (A)
Join the two base brackets (Band C). (B over, C under)
Position the pole (D) on the two brackets and secure with the four screws.
Cover the screws by inserting the cap (E) on the upright pole.

FAN ASSEMBLY

These operations must be carried out with the plug disconnected from the power outlet.
Unscrew the ring nut (P) in a counter clockwise direction.
Position the rear grid (M), with the small hole (N) on the bottom and the 2 small cy linders (0) of the
motor unit which insert in the rear grid compartments .Fastening the ring nut (P).
Assemble the blade (Q) on the shaft (R) of the motor unit. The blade fastening pin (S) of the shaft
must be inserted in the groo ves (T) on the back of the blade.
Fasten the blade to the shaft , screwing in the plug (U) anti-clockwise.
On top , couple the front grid (V) to the rear one.
The small hole (Z) on the bottom must coincide with that of the rear grid for in sertion and fasten
with the screw(X 1) and small nut (X2 ) . Fasten the external closu res (Y).
Insert the assembled fan on the upright pole and secure with the screws (F).
Ad just the height of the pole via the ring nut (G).
INSTRUCTIONS FOR USE
Start the ventilation by pressing keys (W) 1 - 2 -3 depending on the inten sity you want.
If you want to let the fan swing, press pin (L) downwards.
To stop the fan swing, pull the pin (L) upward .
The inclination of the motor section can be modified, tilted at will, there is a snap device that locks
the head in the desired position.
Press Oto stop the air flow.
9