Primus TUPIKE Manual Del Usuario página 5

3.
Check the seals before connecting a new gas container to the appliance.
the appliance if it has damaged or worn seals.
4. The threads on both the gas cartridge and the regulator,
damaged in any way or awry, replace the gas cartridge; or if the regulator is damaged, DO
NOT USE the stove. Order a new hose and regulator – see Accessories on the side flap.
5. Inspect the hose (so that it is neither kinked nor squashed. Avoid twisting the flexible hose)
as well as the connections to the burners that they are not damaged. Lift the pan support
and drip tray to ensure that the hose and connector are properly adjusted.
PREPARE THE STOVE.
to ensure that the stove is standing with its legs fully folded out on a
stable, flat surface with no combustible material nearby. Check its
stability! If you tip the stove while there are pots on it, you risk being
scalded by hot liquids.
1. Stand the stove on its side with the handle
from the slot on the underside.
2.
Unfold the support legs to their outermost extent. Place the stove with its support legs
downwards on a flat surface.
3. Open the lid on the stove by angling the handle 90°.
pointing straight up, otherwise the lid cannot be opened. Lift the lid as far as it will go.
4. Fold out both wind shields to their outermost position.
Do not use
must be intact if they are
Important:
Take care
uppermost. Remove the regulator and hose
It is important that the handle is
5.
In transportation mode, the pan support
the rough sides are uppermost, towards the pot. Ensure that the metal pins on the edges
sit in the holes in the drip tray.
6.
Attach the gas cartridge to the regulator by screwing with a definite continuous motion as
far as it will go. Do this manually – DO NOT USE a pair of pliers, or similar.
7. Make sure that the gas cartridge is level with the regulator upwards. Check that no gas is
leaking from the connection between the regulator and the gas cartridge. Use soapy water
as discussed in the section "Before ignition" if you are unsure.
LIGHTING THE STOVE.
circumstances move the stove when it is lit, either with or without pots.
If, due to the wind, the flames are forced down under the burner, turn
the stove off and move it to a more sheltered location.
1. Rotate the gas supply knob for the burner
anti-clockwise and press the ignition button
2. If the burner does not ignite after five attempts with the ignition button, turn off the supply
(clockwise as far as it will go) and wait ten seconds for the unignited gas to dissipate. Turn
on the gas supply and try again.
3. Once the gas has been lit, you can adjust the flame and the supply of heat with the supply
knob. The gas should burn directly upwards with a steady flame.
4. Put the pot or frying pan on the stove after the gas has been lit.
5. If you need to use two burners, light the second one the same way that you lit the first.
s upside down. Turn the pan support so that
Important:
Under no
you want to light, about one turn
next to the knob to ignite the gas.