Step 2: Assign An Ip Address; Step 3: Print A Network Setup Page - Lexmark MarkNet X2000 Serie Referencia Rápida

Step 2: Assign an
IP address
Note:
Information about other
ways to set an IP address is also
on the drivers CD.
Step 3: Print a
network setup
You must assign an IP address, netmask, and gateway to the print
server in order for other network devices to find the attached printers.
If your network is using DHCP, address values are automatically
assigned. To verify the address assignment, print a network setup
page and make sure the IP address, netmask, and gateway appear
as non zero. Follow the instructions in "Step 3: Print a network setup
page" to view this information.
If your network is not using DHCP, you must manually assign an IP
address. One of the easiest ways is to use the Print Server Setup
Utility on the drivers CD. Click What's on this CD and look for Print
Server Setup Utility to find information about installing and using the
utility.
Press
Test
printer connected to port PAR 1 on the print server.
page
Check under the TCP/IP heading to verify your IP address, netmask,
and gateway settings are non zero.
After the network setup page prints, the printer returns to a Ready
state.
to print a network setup page. The page prints on the
5