Fitting The Side Handle - Rebel RB-1020 Manual Del Usuario

OPERATION
WARNING. Switch off the angle grinder and disconnect it from power supply before
assembly or adjustment.

Fitting the side handle

WARNING. Always use the angle grinder with the side handle attached.
There are two mounting holes on the left and right side of the power tool head. Use them
to attach the side handle. To fit the side handle (7), maximally screw it into the desired
mounting hole.
Operate the angle grinder with both hands. Side handle provides firm grip and the risk of
touching the spinning wheel and injury during kickback is minimized.
Fitting the wheel guard
WARNING. Fit the wheel guard prior to each use. Do not use the angle grinder without
the wheel guard attached!
Position of the wheel guard can be adjusted. This feature allows using the angle grinder
at various angles with maintaining proper protection against flying broken pieces and
accidental contact with a wheel or sparks. It should be fitted so that its covering part faces
the operator whereas the uncovered part faces the workpiece.
To fit the wheel guard (8) follow the below instructions:
• Place the angle grinder upside down on a workbench.
• Put the wheel guard on the spindle so that the notches in the guard fit the protrusions
on the spindle.
• Adjust the position of the guard so that its covering part faces the operator.
• Tighten the screw with the hex wrench.
Fitting and removing wheels
WARNING. Cut-off wheel included in the set is intended exclusively for cutting metal.
ALWAYS use the wheel intended for recommended application (for example: do not grind
with the wheel intended for cutting) and the material of the workpiece.
Use wheels with appropriate diameter and mounting hole size (see Information about the
power tool).
To fit the wheel follow the below instructions:
• Make sure the angle grinder is disconnected from power supply.
• Place the angle grinder upside down on a workbench.
• Make sure the wheel guard is properly attached to the power tool.
• Place the inner flange on the spindle.
• Place the wheel on the inner flange.
• Place the lock nut on the wheel so that its flat surface adheres to the wheel.
33 EN