Initial Operation; Care, Storage - Crivit Pro 290897 Instrucciones De Uso

• Disconnect the product from the char-
ging cable when it is fully charged.
• The product may only be charged in
dry, enclosed, indoor spaces.
Never charge and store the product
close to large sources of heat or open
fire as this could cause the storage
battery to explode.
• If the storage battery burns during the
charging process then do not extinguish
it with water but for example with dry
sand.
• Do not leave the product unattended
during the charging process and look
out for possible overheating.
• Only charge the storage battery at an
ambient temperature of 5–35°C.
• The charging contacts on the device
may not come into contact with metal
objects.
• If the product has been subjected to a
strong impact then store it in a very safe
place for the next 12 hours (e.g. in a
metal box).
• Never try to manipulate, modify, or
repair a storage battery or the product.

Initial operation

Charging the storage battery
(figure B)
1. Connect the micro USB plug (4a) on
the USB cable (4) with the storage
battery plug connection (2a) on the
back light (2).
2. Insert the USB plug (4b) on the USB
cable (4) in the USB port of an active
computer or a charging station with a
USB port.
3. An LED on the back light (2) flashes.
Depending on the charge status one
LED will flash first, then the second LED
flashes while the first LED lights
constantly on. Then the third LED starts
flashing while the other lights are on
constantly.
14 GB/MT
Note: The charging time is approx. 5
hours.
4. The LEDs on the back light (2) light
constantly as soon as the storage
battery is fully charged.
Putting the belt on (figure C)
1. Hold the front light (1) with one hand
and pull your right arm through the belt
loop (3).
2. Take the end of the belt (3b) and pull it
through under your left arm.
3. Close the belt with the ends (3a) (3b).
Switching the light on and off
(figure D)
You can choose between three different
lighting modes for the front light (1).
Press the on/off button to do this (1a):
Press once: Light on (low brightness
level)
Press twice: Light has a moderate
brightness level.
Press three times: Light has a high level of
brightness.
The back light (2) lights are on constantly
on all three lighting modes at the same
level of brightness.
Press on the on/off button (1a) for a long
while in order to switch the lights off.

Care, storage

Never clean the product with aggressive
cleaning agents. Pat dry after use.
Always store the product in clean and dry
condition at room temperature.
Disposal
Dispose of the article and the packaging
materials in accordance with current local
regulations. Packaging materials such as
foil bags are not suitable to be given to
children. Keep the packaging materials
out of the reach of children.