Control Elements - Jupiter Nutrimix Manual De Instrucciones

Operating Instructions Nutrimix
J
Lid
H
Display module
I
J Button
Battery (CR2032)
K
Decorative ring
L
M Tamper housing
Temperature sensor
N
• To activate/deactivate the temperature display, press the
button briefly.
• To switch the temperature display between °C
press the button for longer than 2 seconds.
The temperature display switches off automatically
Info:
after approx. 2 minutes.
Changing the battery
Screw the lid off.
1 H
Carefully remove the display module
2
housing M .
Make sure that you do not pull out the
Important:
display module's power supply cords or disconnect the
plug!
Remove the battery on the underside of the display
3 K
module from its holder. To do this press the tab on the
I
side outwards.
Insert the new battery (CR2032).
4
The positive pole of the battery (
Important:
5 Insert the display module
per housing .
M
When installing note the coding of the dis-
Important:
play module and tamper housing.
Screw the lid on.
6 H
Make sure that the power supply cords of
Important:
the display module do not get caught or jammed!
10 Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information.
H
I
K
L
M
N

from the tamper
I
) is visible.
+
I carefully back into the tam-

Control elements

The Nutrimix is controlled by a backlit, touch-sensitive
control panel. Tapping the symbols selects the relevant
function.
S
R
Q
P
ON/OFF
O
P LCD display
PULSE
Q
R Cleaning program
Program symbols
S
(
Program description
T Manual speed setting
ON/OFF
CAUTION Rotating parts can cause injury!
°F
• Never put your hand into the appliance when the motor
is running.
NOTE Running the appliance while empty can
cause damage!
Never operate the appliance when empty. This can dam-
age the blade mount and/or seal.
• After choosing a program or a speed setting, you can
start or stop processing by tapping
• In addition, the operating status is displayed via the
symbol :
Flashes red
Flashes red and touch
panel is backlit
Lights white
LCD display P
• After plugging into the mains and tapping
ground lighting on the LCD display lights up.
 Standby mode,
• In the left-hand part of the display (
speed level (
1 - 10
running.
O
see Page 13)
.
Operating status
Energy-saving mode
Standby mode
Appliance is running
flashes red
) the current
speed
) is displayed when the appliance is
T
the back-