Printing Operation; Printing In Tear-Off Mode; Printing In Cutting Mode; Synchronizing The Paper Feed - Weidmuller THM Plus S Manual Del Usuario

6

Printing Operation

NOTE
Printhead damage caused by improper
handling!
• Do not touch the underside of the
printhead with the fi ngers or sharp
objects.
• Ensure that the labels are clean.
The printer is ready for operation when all connec-
tions have been made and labels and the transfer
ribbon have been loaded.
6.1

Printing in Tear-off Mode

After printing the label is torn-off manually. For this
the printer is equipped with a tear-off plate.
6.2

Printing in Cutting Mode

The printer version with cutter or perforation cutter is
used to cut off or perforate labels and endless mate-
rial automatically after printing.
The cutting mode must be activated in the
software.
With direct programming it is controlled
with the „C command" → Programming
Instructions.
NOTE
Functional impairment due to dirt!
When using label material, do not cut
through the labels.
1357590000/00/03.12
6.3 Synchronizing the Paper
Feed
After the label stock has been inserted, for cut-
ting mode a synchronization of the paper feed is
required. That way the fi rst label, which is detected
by the label sensor, will be transported to the print
position and all labels in front will be fed out of the
printer. So the synchronization avoids, that the fi rst
cut label would be too long. That can cause useless
fi rst label.
• Press to start the synchronization.
• Remove the blank labels cut during the synchro-
nization
Synchronization is not necessary if the
printhead was not opened between dif-
ferent print jobs, even if the printer was
switched off.
Printing Operation
39