Sony DDU1632 Guia Del Usuario página 9

1. Installing the DVD-ROM Drive
Before you begin, turn off the system power. Follow the steps below to install the DVD-
ROM drive:
1. Remove the cover from your system. Refer to your system user's guide.
2. Adjust the Master/Slave jumpers on the back of the DVD-ROM drive as necessary.
(The factory default is Master. Please refer to Section 4 for more information.)
3. Insert the DVD-ROM drive unit into a free 5.25-inch drive bay. Secure the DVD-ROM
drive to the drive bay rails with the mounting screws included in the DVD-ROM
package. Refer to your system manual for instructions on how to install a drive.
4. Plug a free power connector inside your PC into the Power socket on the back of the
DVD-ROM drive.
5. Plug a free IDE connector inside your PC into the drive's IDE interface socket.
1. Digital Audio
2. Audio Cable
3. Red Strip
4. IDE Cable
NOTE: The red edge of the IDE cable corresponds to pin 1 of the IDE interface on the
DVD-ROM drive.
6. Replace the cover and turn on the power.
Using the wrong type of cable with this product can cause it to malfunction.
:
NOTE
Follow the instructions when connecting the product.
5. Red Strip
6. Power Cable
7. Self test for Factory only
E
1