Eden 373 Manual De Instrucciones página 2

ENGLISH
♦ C heck that the voltage shown on the label of the unit corresponds to the vol-
tage of the mains supply.
♦ C onnect the unit only to power supplies with residual current circuit breaker
(RCCD) with sensitivity of 30 mA.
♦ A lways disconnect all electrical appliances from the mains before placing your
hands in the water.
♦ T he line cord cannot be replaced or repaired. Should the cord become dama-
ged the appliance must be discarded.
♦ U nits marked with
♦ T his unit must not be used in swimming pools or bathrooms.
♦ T his appliance has been designed for use in fluids up to 35°C.
The leads of this unit must be connected as follows: Blue or Black to Neutral or Black-
coloured terminal; Brown to Live or Red-coloured terminal. Earthed units have a
Green or Green/Yellow earth wire and this must be connected to the Earth terminal
on the plug.
MAINTENANCE OF THE PUMP
The motor is fully encapsulated and self protected against overheating and needs no
particular care. If the pump fails to work, check first the electrical supply, connec-
tions, circuit breaker etc. If these are correct, the pump needs to be cleaned.
Regular cleaning of the pump is recommended to remove any debris and lime-scale,
which could block the unit.
Prior to any work on the unit, disconnect all electrical equipment from the mains.
Remove the cover from the motor housing. Pull out the rotor from its location (fig.
1). Carefully rinse all components under running water cleaning with a non-metallic
brush. If necessary remove lime-scale by immersing the components in vinegar or
lemon juice for few hours. Reassemble the unit so that all components are placed in
their original position.
ASSEMBLING THE FILTER
Open the filter:
Insert the supplied caps in their locations (fig. 2)
Mount the suction cups on the base as shown in fig. 3.
Rinse the activated carbon bag in water and place it in the appropriate chamber.
Place the base of the filter in the chosen corner of the aquarium taking care to clean
away any gravel and other debris.
Fix the base by pressing it so that the suction cups are firmly in place.
Connect the pump to the upper part of the filter and lock the cord in its seat (fig. 4).
Place the upper part of the filter on the base, taking care to ensure the parts are
properly seated.
It is recommended to keep the level of the water within the range given in fig. 5.
DECORATION OF THE FILTER
Clean the surface from dust or humidity and just stick the pre-cut decorations where
your like.
MAINTENANCE OF THE FILTER
Prior to any work on the unit, disconnect all electrical equipment from the mains.
Clean the filter when the water flow from the cascade appears insufficient or when the
SAFETY WARNINGS
on the label are for indoor use only.
FOR UK ONLY
CLEANING THE PUMP