ECRON FD-40QII Manual Del Usuario página 35

ASSEMBLY INSTRUCTIONS
1. Place base foot A (18) on top of base foot B (19) to form a cross base.
2. Place the lower tube (15) with the tube base (17) into the cross base
and secure it with the 4 screws provided.
3. Loosen and remove the tube connector (14) of the lower tube. Slide
the decorative tube (16) over the lower tube down to the base. Extend the
upper tube (13), slide the tube connector over it down to the lower tube
and then tighten.
4. Join the motor (11) to the speed regulator (12) on top of the upper
tube. Check that the section of the speed regulator is completely inserted
into the upper tube and that it is fixed securely with the screw included in
the assembly pack.
5. Loosen the guard mounting nut (6) in the motor compartment.
6. Put on the rear guard (7) of the motor compartment and fix it by
EN
turning the guard fixing nut in a clockwise direction. Finally,tighten well.
7. Push the blades (5) along the drive shaft (8) and fix them with the rotor
(4) turning in an anticlockwise direction.
8. Hang the front guard (2) on the rear guard (7) using the mounting
clips (3) located on the edge of the guard. Next, fix the guards with the
hooks. Insert the bolt and screw it into the nut to secure the two grilles
together. Attach the decorative guard (1).
35