Berner BACS-1 10,8V LI Manual Original página 17

OBJ_BUCH-175-003.book Page 16 Wednesday, September 22, 2010 3:44 PM
Always keep the tool holder 2 and the insert tool clean
to ensure the locking and releasing function of the
locking sleeve 3.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Berner power tools.
In all correspondence and spare parts orders, please
always include the 6-digit order number given on the
nameplate of the machine.
Transport
Dispatch batteries only when the housing is undam-
aged. Tape or mask off open contacts and pack up
the battery in such a manner that it cannot move
around in the packaging.
When dispatching lithium-ion batteries, compulsory
labeling may be required. Please observe the respec-
tive national regulations.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must be
collected separately and disposed of
in an environmentally correct manner.
16 | English
Battery packs/batteries:
Li-ion:
Please observe the instructions in
section "Transport", page 16.
Do not dispose of battery packs/batteries into house-
hold waste, fire or water. Battery packs/batteries
should, if possible, be discharged, collected, recycled
or disposed of in an environmental-friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 2006/66/EC.
Subject to change without notice.
1 609 929 U97 • 22.9.10