Advanced System Functions; Drive Lock/Ignition Controlled Door Locks; Turbo Timer Mode; Nd Car Mode (Multiple Vehicle Control) - Firstech, LLC. 2W902R-SP Manual De Usuario

Advanced System Functions

The following section reviews advanced system functions. Many of these functions require multiple steps
or additional programming by your local authorized Firstech dealer to be active.

Drive Lock/Ignition Controlled Door Locks

Tap the Function button <insert icon> once followed by the Lock button to turn the
Drive Lock on and off. (also known as ignition controlled door locks) The remote will beep
once and the LED flash once to confirm that drive lock mode is activated. The remote will beep twice and
LED flash twice to to confirm drive lock is off.
IMPORTANT: Drive lock mode requires the dealer turn on Option 1-9. Drive lock has two settings;
Default 1: Off
Option 2: Locks the doors when the ignition is on and after the brake is depressed.
Option 3: locks the doors when the RPM's have reached two times that of idle speed (this setting
requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual
transmission vehicle, the doors will unlock upon setting the emergency / parking brake.

Turbo Timer Mode

The built in turbo timer keeps the vehicle's engine running for either 1, 2, or 4 minutes
(programmable from dealer) after the vehicle key has been removed from the ignition. This
feature will keep oil running through the turbo system to allow for appropriate cooling time.
Tap the Function button <insert icon> once followed by the Unlock button to turn turbo mode on or off.
The remote will beep once and LED flash once to confirm that turbo mode is activated. Repeat to turn
turbo timer off. The remote will beep twice and LED flash twice to confirm turbo mode is off.
IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the
Firstech system. Consult your local authorized dealer for installation.
nd
2 Car Mode (Multiple Vehicle Control)
nd
This remote has the ability to operate a 2 vehicle with the same system. Note: When in 2nd
Car Mode that your LED will flash blue when the buttons are tapped. Hold buttons
for 2.5 seconds to enter the Remote Option Menu. Tap the Trunk Button to turn
nd
2 Car Mode on. Your remote will chirp once for on and twice for off. The remote's LED will illuminate
nd nd
blue confirming that 2 car mode is activated. The remote will remain in 2 Car Mode until you hold the
buttons for 2.5 seconds, enter the Remote Option Menu and tap the Trunk
Button. The remote will beep twice and you must hold the Trunk and Key/Start buttons
to save the Remote Option Menu changes.
nd nd
IMPORTANT: 2 car mode requires the remote to be programmed to a 2 vehicle that is equipped with
the same remote kit.

RPS Touch and RPS (Remote Paging Sensor)

The RPS is an optional feature. The car call/RPS feature uses a small sensor that is mounted
12