G-Systems FC13-210EU-ACEC-GSE Manual Del Usuario página 13

Manual AC-EC LCD fan controller 2x5A
1. Socket 1 (Exhaust fan 1)
2. Speed bar
3. Temperature
4. Temperature hysteresis
5. Day time
6. Night time
7. Nominal value setting
8. Actual temperature
9. Actual humidity
10. Power LED
11. Control button
Install the AC/EC fan controller on a wall using the holes which you find
removing the cover to a non-flammable surface such as brick concrete and
never on wood, plastic cardboard, etc. Make sure that on your choice of the
place have sufficient ventilation in the location and the heat can be
dissipated. Avoid small un-ventilated rooms or cabinets. Improper
installation will result a overheating of the controller!
Install the light- humidity & temperature sensor which comes with a 4m long
cable at a point where you wish to undertake the measurement. Ensure that
this is not directly exposed to a heat source or stream of light in order to
obtain the best precise measurement of the ambient air as possible.
Connect AC fans exhaust fan to fan1 left socket and intake fan fan2 to the
right socket. Or\and connect EC fans to one of the RJ45 sockets fan1
exhaust fan and fan2 intake fan.
Legend
12. Socket 2 (Intake fan 2)
13. Intake air fan (EC-fan 2)
14. Exhaust air fan (EC-fan 1)
15. Cable gland 12 mm (sensor)
16. Actual fan speed
17. Cable gland 16 mm (power
cable)
18. Maximum speed
19. Мinimum speed
Instructions
Installation
Schematic of the RJ45 connector
X1
1
2
3
+10V(RT)
4
0-10V(GE)
5
GND(BL)
6
PULS_RMP(WS)
7
8
RJ45-8L-S
EN
11