Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING AND WIRING INSTRUCTIONS
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread mounting screws (A) into universal mounting plate or cross bar (B) approximately
1/4 inch (see fig. 1).
3. Secure universal mounting plate or cross bar (B) to outlet box (C) with outlet box screws (D)
(not included).
4. Secure harp (E) to socket (F) with screws (G).
5. Identify color coding of fixture wires (see fig. 2).
6. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black outlet box wire. Do not twist wires.
7. Fit wire connector (H from fig. 1) over wires and twist until there is a firm connection. If
wire connector (H) easily comes off, reattach and check again for a firm connection.
8. Repeat steps 6 and 7 with the white (group B from fig. 2) fixture wires and outlet box wires.
9. Partially thread green grounding screw (I) into side hole (J) on universal mounting plate or
cross bar (B) (see fig. 1).
10. Wrap ground wire from fixture around green grounding screw (I) leaving enough excess
wire to then connect ground wire and outlet box wire with wire connector (H) (see step 7).
11. Tighten green grounding screw (I). Do not over tighten.
12. Tuck wires inside outlet box (C).
FIXTURE ASSEMBLY INSTRUCTIONS
Warning: This fixture is for indoor use only.
1. Install hooks (S) to canopy loops (T) and loops (U) to S hooks (V).
2. Raise canopy (K) to ceiling allowing mounting screws (A) to protrude through openings in
canopy (K) and secure into place with cap nuts (L) (see fig. 1).
3. Install lamp(s). Do not exceed recommended wattage.
4. Thread coupling (M) into nipple 1 (N1).
5. Thread hex nut (O) onto nipple 2 (N2) then thread nipple 2 (N2) onto coupling (M) and
secure with hex nut (O).
6. Place glass shade (P) and decorative cap (Q) over nipple 2 (N2), and secure with finial (R).
7. Turn power back on at circuit box.
4
Publicidad
