Venicci TINUM 2.0 Serie Manual De Usuario página 17

EN
Do not allow the child to stand or sit on the footrest. The impact of a larger load
»
on the footrest may cause damage to the locking mechanisms. When the child
independently gets in and out of the stroller, position the footrest to its lower
position.
Keep the pram elements clean. Dirt on the frame should be removed with a damp
»
sponge and then wiped with a dry cotton cloth. Do not use caustic, sharp, or hard
agents for cleaning as these may be harmful to the pram elements (discolouration,
scratches, etc.). It is recommended to use cleaning agents appropriate for a particular
surface. In the case of any dirt on the pram cover, remove it with the use of a damp
sponge, adding a delicate cleaning agent. Avoid over wetting the stroller seat,
bottom of the carry cot, and bottom of additional sleeping bag (pram of changeable
function) as this may cause deformation of stringer ring elements.
To avoid weepings or smudges which may occur after rainfall, for instance, secure
»
the pram against over soaking by the use of rain cover for the whole pram. It is
recommended to protect the pram against the effects of strong sunlight. The
manufacturer cannot accept responsibility for deterioration to the pram cover, which
result from failure to follow these recommendations.
Before mounting and dismounting the wheels, lift the locking mechanism of the
»
brake upwards (unblocked break). We recommend that the pram axles should be kept
clean. Where prams are equipped with wheels without bearings, pram axles should
be kept lubricated with a thick agent (cup grease, machine oil) to reduce friction on
tube ends.In models equipped with wheels with bearings, it is recommended to
lubricate the axles with a lubricating agent e.g. WD40.WARNING: Accessories or
spare parts that the manufacturer or distributor has not approved must not be used.
For chassis equipped with mounting holes for the car seat - all connectors that the
»
manufacturer or distributor has not approved must not be used. The manufacturer
is not liable for the consequences of installing other car seats onto the chassis that
do not have their approval. List of car seats with suitable approvals are posted on the
manufacturer's website.
Adaptors for the car seat that the manufacturer or distributor has not approved must
»
not be used. WARNING: Check that the car seat attachment devices are correctly
engaged before use.
While folding and unfolding the chassis, and during assembling stage, keep your
»
hands at a safe distance from moving parts to avoid injuries.
Do not use the combination of the car seat and chassis as a place for the child to
»
sleep for long periods of time. If your child wants to sleep, always use the carry cot or
cot bed. The pram is used as a means of transport, do not rock the product. Moving
the pram forward and backward on short distances the front wheels should be locked
on to the fixed position. Technological looseness of the spinning mechanism, may
cause a change in direction which does not prove product defectiveness.
The manufacturer recommends fitting the car seat in the opposite direction to the
»
direction of traveling(parent facing), it makes easier to observe the child in the car
seat.
For pram designed from birth upwards it is recommended that the child lays in flat
»
position at all times.
For carrycots equipped with a harness, always make sure that if the harness is not in
»
17