GE GME04GGHWW Manual Del Propietario E Instrucciones De Instalación página 9

Hinge cover
Plug buttons
or screws
Plug
button
Plug
buttons
Center
hinge
Spacer
Leveling legs
2-Door Reversal (on some models)
1. Remove the small plug button on the left
Hinge
side of the door top cap.
2. Remove the 2 plug buttons or screws on
the left side on top of the cabinet.
3. Remove the plastic hinge cover by lifting
it up by the front edge.
4. Remove the 2 screws from the top hinge.
5. Lift the freezer door up and off the middle
hinge (right side). Set the door on a non-
scratching surface with the outside up.
6. Remove the center hinge by removing
the 2 screws. Lift the hinge to remove.
7. Lift the fresh food door off of the bottom
hinge. Set the door on a non-scratching
surface with the outside up.
8. Tilt the refrigerator cabinet back to
remove the left leveling leg.
9. Remove the screws on the bottom hinge
(right side) and remove the leveling leg.
Move the bottom hinge to the left side
and secure it with screws. Re-install the
leveling legs.
IMPORTANT: The left leg has a spacer or
spacer feature that must be moved to the
right side leveling leg when the door swing
is reversed.
Screws
Bottom
hinge
10. Screw the right leveling leg, with the
spacer, back in place on the right side.
11. Remove the two plug buttons on the left
side at the center and install them on the
right.
12. Position the door on the left bottom
hinge. With the magnetic gasket holding
the door in place, make sure the door is
aligned with the refrigerator, and secure
the center hinge on the left with screws.
13. Place the freezer door on the center hinge
over the pin. Assure the door is aligned
horizontally and vertically, and that the
gasket seals on all sides.
14. Replace the top hinge on the left side with
screws.
15. Replace the hinge cover on top of the
hinge.
16. Put the plug button in the hole on the
right side of the door cap.
17. Put the 2 plug buttons on the right side
on top of the cabinet
9