Metal Cutting; Laser Safety; Technical Data - NUTOOL NJ480 Traducción De Las Instrucciones Originales

Metal cutting

When cutting metals a suitable cooling/cutting oil must be
used. Simply squirt the lubricant onto the blade or work piece
at regular intervals during cutting to reduce blade wear.
Note: Do not immerse in water or allow coolant to enter the
casing. A fatal electric shock could occur.
Circle cutting
When starting a cut from the centre of the work piece, drill
a 12 mm diameter hole to ensure that there is enough
clearance for the blade.
Tip
When cutting materials with a decorative or polished finish
cover either the base of the Jigsaw or the surface of the
material being cut with masking or other suitable tape to
prevent scratching.

Laser safety

The Laser guide line used in this product uses a class 2
Laser with a maximum power output of 1.5mW at a wave
length of between 635 and 670nm. These lasers do not
normally present an optical hazard, although staring at the
beam may cause temporary flash blindness.
WARNING!
Do not stare directly at the Laser beam.
The laser shall be used and maintained as detailed in this
manual.
Never intentionally aim the laser beam at any person and
prevented it from being directed towards the eye or an
object other than the work piece.
Always ensure that the laser beam is directed at the work
piece only when it is located on the mitre saw table.
Never direct the laser beam onto any bright, shiny reflective
surface, the laser beam could be reflected back towards
the operator.
Do not change the laser unit for any other type.
Do not tamper with the laser unit except when making
adjustments.
Repairs to the laser must only be carried out by an
authorised service centre

10 TECHNICAL DATA

Voltage
Rated Power
No load speed
Cutting Angles
Sound Pressure Level
Sound Power Level
Vibration Level (when cutting)
Weight
Max cutting capacity
Wood
NJ480
230 V ~ 50 Hz
480 W
0-3000 min
-1
15° - 30° - 45°
LpA 85.5 dB(A)
LwA 96.5 dB(A)
wood: 7.411 m/s
sheet mild steel: 7.698 m/s
1,6 kg
60 mm
15
NJ750L
230 V ~ 50 Hz
750 W
0-3100 min
-1
15° - 30° - 45°
LpA 91 dB(A)
LwA 102 dB(A)
wood: 5.84 m/s
2
sheet mild steel: 4.42 m/s
2
2,02 kg
80 mm
GB
2
2