Berner BPT-ROS 150 Manual página 7

4. Maintenance
Generally for the device maintenance the environmental regulations of the respective country are to be observed.
After first year, disassemble and inspect the tool every three 3 months if the tool is used every day. Replace damaged or worn parts.
Always ensure that the machine is disconnected from energy source (compressed air) to avoid accidental operation.
To keep downtime to a minimum, use repair kit define in parts list.
Motor Lubrication
• 1. Only use BERNER accessory air oil
2. Clean air intake nipple before use
3. Fill air oil (approx. 3 drops) into the air intake nipple and briefly operate the machine.
• Follow abovementioned steps before and after using the machine. This increases the machine's service life.
5. Disposal
The disposal of this equipment must follow the legislation of the respective country.
All damaged, badly worn or improperly functioning devices MUST BE TAKEN OUT OF OPERATION.
Repair only by technical maintenance staff.
Use the equipment only for its intended use as described above, any other use is expressly excluded! We are not responsible for injuries
and damage due to inappropriate use and misuse and/or noncompliance of safety precautions; this is not covered by the warranty.
Valid for:
201149
Origin of the product: Made in Taiwan
is in conformity with the requirements of the council Directives on the approximation of the laws of the Member States relating :
to „Machinery":
applicable harmonised standard(s) :
Berner Trading Holding GmbH
Technical File
Bernerstraße 6
available at the
74653 Künzelsau / Germany
EU Technocenter
Berner Trading Holding GmbH
Company name
Bernerstraße 6
and address:
74653 Künzelsau / Germany
We hereby declare that the following described machine complies with the general safety and health requirements of below mentioned EU directives due to its design and
conception and the type circulated by ourselves. This declaration becomes invalid if the machine is modified without our approval.
EC DECLARATION
2006/42/EC (17/05/2006)
EN ISO 11148-8:2011
EN
Serial: 011 to 129
Place and date
of issue:
ARMIN HESS
Chairman of the Management Board
74653 Künzelsau
Germany
28-03-2014
7