Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT INSTRUCTIONS
Read and save these important safety instructions
before using this fan, when using electrical appliances,
basic safety precautions should always be followed
including the following:
WARNING - To reduce the risk of fire or electrical shock,
do not use this product with any solid state speed control
device. To reduce the risk of fire or electric shock and
injury to persons, do not use in a window.
Use this fan only as described in this manual. Other
uses not recommended may cause fire or electric
shock.
This product is intended for HOUSEHOLD USE ONLY
and not for commercial, industrial or outside use.
To protect against electrical shock, do not place fan in
window, immerse unit, plug or cord in water, or spray
with liquids.
Unplug the fan from the outlet when not in use, when
moving fan from one location to another and before
cleaning.
Do not operate the fan in the presence of explosive
and/or flammable fumes.
Do not place the fan or any parts near an open flame,
cooking or other heating appliance.
Avoid contact with moving fan parts.
To disconnect, grip the plug and pull it from the wall
outlet. Never yank the cord.
The use of attachments is not recommended and
may cause hazards.
Always use on a dry, level surface.
Do not operate if the fan housing is removed or
damaged.
Do not operate any fan with a damaged cord or plug.
Discard fan or return to an authorized service facility
for examination and/or repair.
Do not run cord under carpeting. Do not cover cord
with throw rugs, runners, or similar coverings. Do not
route cord under furniture or appliances. Arrange cord
away from traffic area and where it will not be tripped
over.
The appliance is not to be used by children or persons
with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have
been given supervision or instruction.
Close supervision is necessary when any appliance is
used by or near children. Children being supervised not
to play with the appliance.
ASSEMBLY INSTRUCTIONS
Pass the cord through the base. Assemble the two
base halves together. Position the base half with the
alignment pin, over the other base half with the
alignment sockets. Press the two halves together until
flush. (See figure A.)
Assemble the base to the tower bottom. With the tower
on its side, align the 4 base sockets onto the tower
bottom pins. Tighten the screws securely but do not
over tighten.
HOW TO OPERATE
Set the fan on a level and dry surface.
Plug the power cord into the socket.
Making sure the speed control is at OFF position.
To operate the fan, rotate the switch knob
counter-clockwise to the desired speed
Low(1), Med(2), High(3).
To Oscillate the fan, rotate the switch
knob clockwise to the desired speed
with oscillation
Low(1), Med(2), High(3).
O
3
2
1
O
O
3
2
1
O
Publicidad
