PROEL phantom100 Manual De Uso página 2

INTRODUCTION
The PHANTOM100 provides clean and hum-free +48 V power supply for all condenser microphones.
The PHANTOM100 is suitable for all applications where +48 V power supply is not available from mixing console
(direct recording to PC, use of devices with no phantom power, fixed installations, etc.)
It is powered by DC adaptor (included).
CONTROLS AND AUDIO CONNECTION
1. PWR - switch
The power switch is used to turn on the phantom power on the INPUT female connector.
NOTE: To prevent damaging of your speaker and avoid switching noise, first connect the DC adapter, second
the condenser mic to the PHANTOM100 and the PHANTOM100 to the mixer, then switch on the PWR switch
and finally switch on the mixer's channel where the PHANTOM100 is connected.
2. ON - red LED
The ON LED shows when the PHANTOM100 is powered. If the led doesn't light, be sure that the power adaptor
is connected to the mains line and the PWR switch is activated.
3. INPUT - female XLR
Connect the condenser microphone or the device that require the 48 V phantom supply to this XLR female
connector. It is wired with pin-1 ground signal and 0 V reference, pin-2 hot signal and +48 V, pin-3 cold signal
and +48 V.
4. OUTPUT - male XLR
This male XLR output connector is the balanced microphone level output of the PHANTOM100 and it is wired
with pin-1 ground, pin-2 hot and pin-3 cold. This connector doesn't have the phantom power and can be
connected to any audio device with microphone input.
5. 9VDC socket
Here's where you plug in the included DC adapter.
CONDENSER
MICROPHONE
MICROFONO A
CONSENSATORE
ENGLISH
MIXER WITHOUT PHANTOM
MIXER SENZA PHANTOM