Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY
before use!
When working with the device, make sure you
•
spraying fragments.
•
•
recommended.
•
Depending on the materials you are
recommended to protect from airborne dust.
• The device is only to be used by those who have
should it get into the hands of children.
• The tool should not be connected to a
compressed air tube that exceeds a pressure of
6.0 bar.
• Air compressors must comply with the
requirements of ANSI B 19,3 1981 (US) "Safety
• The hose must be designed for a minimum
pressure of 10.3 bar or 150 psi, a minimum of
150% of the maximum pressure produced by
the system.
• So that the pressure can be completely released
and the feed hose must be joined with a hose
coupling!
• The tool must not be used when it is not sealed
or needs to be repaired!
•
soon as it is no longer being used.
• Take care when using the tool to ensure you
• Hydrogen, oxygen, carbon dioxide or other
gases may not be used as an energy source
under any circumstances. This could cause an
explosion and result in serious injury.
• Always carry the device by the handle and
never by the control trigger!
• Only use the tool with the prescribed pressure
(= max. 6.3 bar).
• Never under any circumstances use the device
• When the device is not being used, store it in a
dry place that's not cold and is out of the reach
of children.
•
designed for the device.
•
or to any of its parts!
• Observe
all
cleaning,
maintenance
and
to guarantee future use free from faults. Any
• Children or people with reduced physical,
without knowledge or experience must not
use the device, unless supervised by a person
responsible for their safety or having received
• Children should never be allowed to play with
the device!
Before using the device, make sure that you pay
the paragraph "Intended use"!
• To ensure a long service life can be guaranteed,
you must oil the tool before each use and check
www.Deuba24online.de
Storage".
•
•
• Connect the tool to the compressed air hose.
• Never operate compressed air tools without
oiling them!
Commissioning
Quick Coupling Connector
Compressed Air Tube
Quick Coupling Connector
Pressure Regulator
Filter
Oiler
Snap Locking Joining Enclosure
• Screw a ¼ inch (6.35 mm) coupling piece
compressed air tool.
•
recommended otherwise the device might not
perform to its full capacity.
•
hose, you should never direct the pointed end
of the tool towards yourself or others.
• Do not press with excessive force on the
workpiece, as this could cause damage.
• The best results are produced when you hold
the needle scaler at a slight angle and slowly
move it with light pressure over the area to be
cleaned.
•
pressure using the pin next to the air intake at
8
9
www.Deuba24 online. de
Replacing the head
If the scaler head is worn or damaged it must
be replaced. Ensure you follow the procedure
below:
1. Using the Allen key, loosen the 3 head screws.
2. The head should now be easy to turn.
3. Take the new head and screw it in securely by
hand.
4.
securely on the device.
1
Compressor
3
CLEANING / MAINTENANCE / STORAGE
securely in place before carrying out any work!
Otherwise, there is considerable risk of injury
from moving parts.
Do not carry out work on the device that is not
Cleaning
use using a dry cloth.
2
4
Publicidad
