monzana DBDL005 Manual Del Usuario página 9

• Make sure that the compressor used has the
right amount of power for the compressed air
tool → CFM
• Do not exceed the maximum air pressure of the
device during use. If the air pressure is too high
or the air supply is contaminated, there will be
greater wear and tear on the tool.
•
gets into the tool it can cause damage.
• Always use the proper hose and hose connector.
It is not recommended to connect the quick
connect adapter directly with the device, as
A guide hose should be used to make the
• The tubes should be kept away from heat, oil
and sharp edges. Check for wear before each
ASSEMBLY
1. The stop bracket can be removed when
changing the saw blade but it must always be
put back in place before use. Using the device
without the stop bracket can lead to serious
injury! To remove the stop bracket, loosen the
two adjustment screws with the Allen key as
shown. To put it back in place again, place it
adjustment screws with the Allen key again.
Adjustment Screw
Allen Key
Saw Blade
Atop Bracket
2. To change the saw blade, open the chuck cover
it upwards.
Chuck Cover
Adjustment Screw Saw Blade
Allen Key
3. Using the Allen key as shown, loosen the
two adjustment screws to remove the saw
adjustment screws. Close the chuck cover then
will damage the threads.
Chuck Cover
Adjustment Screw Saw Blade
Allen Key
USE
be angled to rest on the sheet to ensure a smooth
4. When the saw blade is securely installed,
press the safety lever forward so the trigger
trigger.
5. Now operate the device with both hands to
force on it.
6.
the device from the air supply to prevent
accidents. Expel any residual pressure safely
from the device.
www.deubaxxl.de
Maintenance/Cleaning
•
any maintenance or checks.
• Check all parts for signs of wear. If any problems
are detected, do not use the product. Always
replace all parts with original replacements
according to the manufacturer's guidelines.
• If the product is not properly cared for and
maintained, it can become unsafe and can also
become damaged. This can lead to dangerous
• Regular maintenance on the product helps to
make the product safe and will also increase its
lifespan.
• Use a clean, dry cloth to clean the outer surface.
• Make sure that the casing, air inlet and saw
blade are free from debris and dirt.
PROBLEM POSSIBLE CAUSE
The power has 1.
decreased.
2. The trigger is obstructed.
3.
4. Air is leaking through a
loose casing.
5. The mechanism is
contaminated.
The casing gets 1.
hot during use.
2. Worn parts.
There is 1. The casing is loose.
2. The valves and / or casing
leakage (slight are damaged.
air leakage is 3. Valves are dirty / worn /
normal). damaged.
16 17 www.deubaxxl.de
• The trigger's pivot point must be cleaned
regularly with a light machine oil.
• Before the hose is connected for use, always
not use cleaning oil!
• Before each use, check that the stop bracket
and saw blade are securely in place, otherwise
•
once a week during regular use.
The following table shows possible faults and
During maintenance, disconnect the device from
the compressed air supply.
SOLUTION
1.
with the required pressure.
2. Clean the area around the trigger.
3.
4.
securely.
5. The mechanism can be cleaned by a technician.
1.
2. The internal mechanism can be checked by a
technician, who may need to replace parts.
1. Tighten the casing. If it cannot be properly
aligned.
2. Replace damaged parts.
3. Clean the valve unit.