Uline H-4833 Instrucciones De Montaje

H-4833
25" PACKING
TABLE DRAWER
TOOLS NEEDED
Flathead Screwdriver Phillips Screwdriver
10 mm Wrench 5/32" Drill Bit and Drill
(if attaching to wood top)
ATTACHING TO STEEL TOP
NOTE: Mounting channels are included with
the steel top. Channels may extend past the
drawer assembly.
Mounting Channels
1. Turn the packing table over. On the underside of
the table, slide mounting channels front to back
into table flanges. When channels are aligned,
mounting holes should be approximately 23½"
apart. Secure each channel with two 1/4"-20 x 5/8"
bolts. (See Figure 1)
2. Open the drawer. Attach the drawer assembly to the
mounting channels using eight 1/4"-20 x 1/2" bolts.
(See Figure 1)
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
ASSEMBLY
Some parts may have sharp edges.
Care must be taken when handling pieces
to avoid injury. For your safety, wear a pair
of work gloves when assembling.
3. Close the drawer and turn the packing table right
side up. Cycle the drawer in and out a few times to
check operation.
NOTE: The drawer and suspension have a 50 lb.
weight capacity.
ATTACHING TO NON-STEEL TOP
1. Turn the packing table over. Open the drawer.
Position the drawer assembly in the desired
location. Use the drawer assembly as a template
to mark the location of eight holes for wood screws
on the underside of the top. Using 5/32" drill bit, drill
holes into the wood top about 1/2" to 3/4" deep.
(See Figure 2)
2. Attach the assembly to the top using eight wood
screws. (See Figure 2)
Figure 2
3. Close the drawer and turn packing table right side
up. Cycle the drawer in and out a few times to
check operation.
NOTE: The drawer and suspension have a 50 lb.
weight capacity.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0321 IH-4833