MAC TOOLS MBD100B Instrucciones De Instalación página 2

ASSEMBLY INSTRUCTIONS - ADDING TO UC3016-1DRW CART
1
#16
#15
Back Side
#14
Bracket (#20)
Back View of Cart
Step 4 Align Add-A-Drawer to operational and cosmetically straight.
Step 5 Tool Needed: Phillips® #3 Screwdriver & 13mm Combo Wrench
Torque all four bolt assemblies to 5 ft-lbs
Step 6 Tool Needed: Phillips® #2 Screwdriver
Center the handle (#23) onto the holes of the drawer (#21) and
insert the six pan screws (#22) and tighten to 3 ft-lbs.
MBD100B/ MBD100B-BK/ MBD100B-BL/ MBD100B-LG/ MBD100B-OR ADD-A-DRAWER UNIT
Step 1
Locking Top
2
Assy (#1)
(back view)
#14
#15
#16
MBD100B
Add-A-
Drawer
MBD100B/MBD100B-BK
MBD100B-BL/MBD100B-LG
Tool Needed: Phillips® #3 Screwdriver & 13mm Combo Wrench
Turn cart so the back is facing you. Remove bolts assemblies
(#14, #15, #16) from bottom rear right and left from the Drawer
Back Side Bracket (#20).
Locking Top
Assy (#1)
#18
Front View of Cart
6
Handle (#23)
2
MBD100B-OR
ADD-A-DRAWER UNIT
14
16
(Incl. #14, #15, #16)
RSDWRBK Bolt kit
Step 2 Place washer (#15) onto
round head bolt (#14).
Insert from top of the front
bottom left bolt hole on the
left slide holding bracket (#18),
and into front left bolt hole
of MBD100B. Place washer (#15)
and then hex nut (#16) onto
bolt assembly and loosely tighten.
MBD100B Step 3
Repeat for front right, rear left
Top Edge
and rear right.
(Above
Drawer)
(6) Pan
Screws
(#22)
Drawer (#21)
15
07/16/2020