Helo CAMERA-B-KIT Guia De Inicio Rapido página 9

EN
V. Adding Device
1. Add Base Station
1 Please connect your mobile and base station to one router.
2 Open "Helo by Strong" App, click the top right "+" to add
device.
3 Select "Video Surveillance—Base Station", follow the
instructions to add the base station.
2. Add Camera
1 Please press the On/Off button of all cameras one by one.
2 Then the cameras will beep, and the indicator light of the
camera starts to fl ash red; If the indicator light does not fl ash red,
please press and hold the reset button for 5s to reset the camera.
3 Enter the Base station interface on the app, click the "+Add
Device" in bottom, or press the pairing button on top of the
base station to enter pairing status, the Indicator light 2 will fl ash
green.
4 When the camera successfully pairs to base station, a voice
prompt will be heard from camera and camera's indicator light
will turn green, while Indicator light 2 of base station will turn off
and base station exit the pairing status. Then the added cameras
will be displayed on the app.
5 If there is any camera that could not pair to the base station,
please add the camera again following the above +1 +2 +3
+steps.
VI. Charging Camera
1. The camera is with built-in 6000mAh rechargeable battery.
2. When charging, please use the camera USB cable to connect
camera and camera adaptor, then plug the adptor into power outlet
(100v-240v) for charging. The indicator light on camera will turn