Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12

Speci cations

Model
RP-PB053
Battery Capacity
3.2V/18000mAh/57.6Wh
Starting Current
300A
Peak Current
600A
Input
15V/1A
iSmart USB Output1
5V/1.5A Max
iSmart USB Output2
5V/2.1A Max
Car Cigarette LighterOutput
12V/10A
Net Weight (Battery Pack)
861.6g/30.3oz
Dimensions
18.5x13x3cm/7.3x5.1x1.2 in
Battery Level Indicator
Indicator
Unlit
5 Flashing
1 Solid
Battery Level
0%
10%
20%
Charging the Battery Pack
There are two ways to charge the battery pack:
Connect the battery pack with any power outlet using a home power adapter and the 15V input port.
Connect the battery pack with the car cigarette lighter using the car charger cable and the 15V input port.
Jump Starting Cars
1. Make sure the Cable Indicator is o . Connect the blue plug until it is fully seated inside the host.
2. Connect Red Clamp to the positive (+) battery terminal and the Black Clamp to the negative (-) battery terminal.
3. Operate following the instruction of the Cable Indicator:
2 Solid
3 Solid
4 Solid
5 Solid
40%
60%
80%
100%
GREEN LIGHT on: The
connection is correct and
the circuit is working, you
can turn on the engine to
jump start your vehicle.
GREEN LIGHT blinking and
buzzing: The vehicle
battery is low. Press the
"BOOST" button and wait
Beep,Beep
until the GREEN LIGHT
becomes solid, then turn
on the engine within 30
seconds.
4. Start the vehicle.
5. When the vehicle is started, remove the jumper cable from the vehicle battery. Leave the vehicle's engine running.
Charging Mobile Devices
Use any of the two USB charging ports to charge mobile devices, such as smartphones and tablets.
Connect the battery pack with your mobile device using the included USB cable.
Turn the battery pack's power on to start charging.
LED Flashlight
Press and hold the Switch button to cycle through the di erent ashlight modes: ON, Warning (quick ash),SOS
(slow ash), and OFF.
RED LIGHT with buzzing
sound: The connection is
wrong, please readjust
your clamps based on step
Beep,Beep
2 above. Wait until the
GREEN LIGHT is on to turn
on the engine.
No Lights on, no buzzing:
The vehicle's battery may
be damaged. Please
con rm the clamp
connection is correct, then
press the "BOOST" button
and wait until the GREEN
LIGHT turns on. Turn on
your engine within 30
seconds.
03/04

Publicidad

Tabla de contenido
loading

Tabla de contenido