Disposal Requirements - Foster LR150 Manual Del Usuario

GB
Important Note to the Installer:
Please ensure that this document is passed to the user as it
contains important guidelines on operation, loading, cleaning and
general maintenance and should be kept for reference.
General Electrical Safety
Foster Refrigerator recommends that the equipment is electrically connected via a Residual Current Device; such
as a Residual Current Circuit Breaker (RCCB) type socket, or through a Residual Current Circuit Breaker with
Overload Protection (RCBO) supplied circuit.

Disposal Requirements

If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in accordance
with national laws and regulations.
Start-Up and Test Sequence
After unpacking, clean and allow the cabinet to stand for 60 minutes before turning on (cleaning
directions supplied within this manual). Ensure the cabinet is situated on a firm, level surface, away from both
hot and cold air sources, as this will affect its performance.
Make sure that a minimum clearance of 50mm above and around the cabinet is available for ventilation and
effective operation.
Connect the unit to a suitable mains power outlet and turn the supply on. Please do not plug or unplug the unit
with wet hands. The cabinet will start automatically displaying the actual internal temperature of the unit (area
where product is stored).
As the operating temperature has been pre-set no adjustments are required. Allow the cabinet to reach its normal
operating temperature before loading with product.
Display Icons and Buttons
Icons
Alarm Warning
Thermostat Output Active
Fan Output Active
Defrost Output Active
2nd Parameter Set Active
1
Buttons
Info & Set Point
Manual Defrost & Decrease
Increase & Manual Activation
Standby/Exit