Sync Recording; Checking The Remaining Md Recording Time; Checking The Recorded Tracks; Timer Recording - Teac MD-5 Manual Del Usuario

Sync Recording

The deck starts recording when the input
audio exceeds a certain level and pauses
when the input audio has dropped below a
certain level continuously for 4 seconds or
more.
1. Perform steps 1-6 of "Recording an MD"
on page 8.
2. Press the [SYNC REC] button on the
remote control unit. The deck enters the
Sync Record-Pause mode.
(" " and " " light up.)
... The remaining recording time appears
after "S_SYNC ON" is displayed.
3. Start playing the source component.
... The deck starts sync recording upon
detection of the input audio signal.
It pauses when the input audio level
drops below a certain level.
... You cannot start recording manually
by pressing the [ ¥ PLAY] button or
[ π PAUSE] button in the Sync Record-
Pause mode.
... Press the [SYNC REC] button again to
cancel sync recording. After "S_SYNC
OFF" is displayed, the remaining
recording time appears.
Notes:
... Pressing the [
π PAUSE] button during
sync recording aborts the Sync Record
operation.
... Changing the input or mode with the
[INPUT SELECTOR] or [REC MODE]
switch during sync recording aborts the
Sync Record operation.
Buttons used on this page
Checking the Remaining MD
Recording Time
With each press of the [DISPLAY] button,
the display changes as follows:
In the Stop /Record mode:
... The remaining recording time (REMAIN)
is only displayed in the Record-Pause
mode.
... The disc title can be displayed only when
it has been recorded onto the MD.

Checking the Recorded Tracks

ª Press the [ ¥
after stopping recording.
The track which has just been recorded will
be played from the beginning.
∑
Recording
ª To play from the first track of the MD
after recording:
Press the
immediately after stopping recording then
press the [ ¥ PLAY] button.
∑ ªSTOP
Recording
PLAY] button immediately
ªSTOP ∑ ¥PLAY
[ ª STOP] button again
∑ ªSTOP ∑ ¥PLAY
– 11 –

Timer Recording

By connecting this deck with a timer
(commercially available), you can start and
stop recording operations at a preset time.
1. Perform steps 1 to 6 of "Recording an
MD" on page 8.
2. Set the [TIMER] switch to [REC].
3. Set the [TIMER] so that it starts and stops
power supply at the desired start time
and end time.
... As the actual recording starts after the
"TOC Reading" operation, set the timer
recording start time to slightly before the
time when you want to start recording.
... Each component power is turned off.
... When the start time comes, power is
supplied to the components and
recording starts.
[CAUTION]
... When timer recording is performed in
the "SHUFFLE" mode or "PROGRAM"
mode, the deck automatically enters the
"CONTINUE" mode.
... Be sure to turn the deck on again and
eject the MD within 3 or 4 days of timer
recording. When the MD is ejected, the
recorded contents will be written on the
MD. If the deck is left off for a long time
after the timer recording has finished,
the contents may disappear.
... During timer recording, recording starts
from the end of the previously-recorded
portion on the MD.
... Set the [TIMER] switch to [OFF] after
timer recording. If the timer is left in
[REC], the deck will automatically start
recording the next time the power is
turned on.