Bradley S19-899 Manual De Instrucciones página 2

S19-899
Installation
Fill and mount tank
1. Pour clean, potable water into the tank; continue
pouring until the tank is 1/3 to 1/2 full.
2. Pour the entire contents of the water
preservative bottle into the eye wash tank.
3. Add clean, potable water to the tank until the
water level reaches the top of the tank.
4. Insert one liner into the cap with hole and attach
the cap to the top of the eye wash tank (make
sure the cap is tightly closed) (see Figure 1).
NOTE FOR TANK INSTALLATION: To ensure proper
installation, the tank should be placed on the pedestal
from the front of the unit.
5. Invert the tank and place it on top of the
pedestal as shown in Figure 2. The pierce on
the pedestal will puncture a hole in the tank cap
liner and allow the solution to flow.
6. Raise the arm to snap fit in an upright position,
then secure the tank to the pedestal using the
side tank clamps. Make sure the latches are
pulled down tight to the pedestal (see Figure 2).
NOTE: After the tank is mounted to the pedestal,
minor spillage could occur. Allow the fluid to stabilize
completely before inspecting the unit for leaks.
2
(insert liner into cap before
Figure 1
Pedestal
Cap
Figure 2
2/17/11
Cap with hole
Liner
attaching cap to tank)
Tank
Tank
Bradley Corporation • 215-1272 Rev. G; ECM 11-05-002
Installation
Turn cap to close
Snorkel
Clamp
Latch
Pierce