Publicidad
Step 12
Step
Carefully turn your unit over onto its front edges. Unfold one of
å
the BACKS (I) and lay it over your unit.
A perforation in the BACK (I) has been provided for access
å
to the SAFETY STRAP (60M). Punch out the perforation and
push the SAFETY STRAP through the hole.
Make equal margins along all four edges of the BACK (I). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (I) to your unit using the NAILS (1N). Do not
å
fasten the edge that lays over the UPRIGHT.
Next, fasten the other BACK (I) to your unit using the NAILS.
å
The BACKS will overlap each other. See the enlarged diagram.
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHTS (D2 and E2) and SHELVES (H2).
These holes must line
up over the UPRIGHTS
and SHELVES.
Page 16
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
I
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(91 used in this step)
I
I
1N
I
Publicidad
