Hisense 40H4C1 Manual Del Usuario página 21

... and then cable TV channels.
Tip: Cable TV channels are channels from a cable TV provider that you can receive by connecting their cable directly to
your TV (unscrambled NTSC, ATSC, and QAM channels, if you're interested in the details). In many cases, your cable
provider probably requires you to use their set-top box and connect it to a different input, and then use the set-top box to
tune your cable stations. In that case, you can skip scanning for cable channels.
7. When the channel scans finish, the TV shows the number of channels it added.
Scanning for channels can take several minutes.
NOTE
• You should plan to repeat the channel scan periodically to make sure you are receiving all of the latest channels.
Broadcasters add and remove channels, move channels to different parts of the spectrum, and change the power levels
of their channels periodically. You'll also have to repeat the channel scan if you remove the Antenna TV tile from the
Home screen or perform a factory reset. To repeat the channel scan at any time, go to Settings > TV inputs > Antenna
TV > Scan again for channels.
Now, you're ready to watch broadcast TV! While you're watching, try the following:
Press [UP] or [DOWN] to change channels.
Press [LEFT] to display the channel list and then use [UP] and [DOWN] to select a channel to watch. Or press [REVERSE]
or [FORWARD] to jump a page at a time.
Press [OK] to display information about the current program.
Press [ ] to switch to the previously tuned channel.
Press [ ] to see options for picture and sound settings.
Remote control on page 19
Setting up Antenna TV
has more information on using the remote control buttons while watching TV.
17