Important Safety Information; Compliance Information; Weee Notice - Klipsch T5 TRUE Manual De Usuario

IMPORTANT SAFETY INFORMATION

1. READ these instructions.
2. KEEP these instructions.
3. HEED all warnings.
4. FOLLOW all these instructions.
5. DO NOT use this apparatus near water or
moisture.
6. If you hear ringing or experience pain or
discomfort in your ears during or after using
any in-ear audio product, that is a sign you are
listening too loud.
When your ears are exposed to high volumes (in
excess of 85dB) for over an hour, you may be
permanently damaging your hearing.
7. TURN DOWN your listening device's volume to
zero before you insert the Klipsch headphones
and turn on the device. Once you have the
headphones on, gradually increase the volume
to a comfortable, moderate volume.
DO NOT install near any heat sources such as
8.
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. ONLY USE attachments/accessories specified by
the manufacturer.
10. REFER all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or
has been dropped.

COMPLIANCE INFORMATION

EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to European
Union Low Voltage Directive 2006/95/EC; European
Union EMC Directive 2014/53/EU; European Union RoHS
Directive 2011/65/EU; European Union WEEE Directive
2002/96/EC; European Union Registration, Evaluation,
Authorization and Restriction of Chemicals (REACH)
Directive 1907/2006.

WEEE NOTICE

Note: This mark applies only to countries
within the European Union (EU) and Norway.
This appliance is labeled in accordance with
European Directive 2012/19/EU concerning
waste electrical and electronic equipment
(WEEE). This label indicates that this product should
not be disposed of with household waste. It should be
deposited at an appropriate facility to enable recovery
and recycling.
10
11. NEVER operate a motor vehicle while listening
to or wearing your headphones. Not only
dangerous,
it is illegal in many places.
12. NEVER operate heavy machinery while listening
to or wearing your headphones.
13. We don't recommend you use the headphones
while riding a bicycle, running,or walking in
heavy traffic areas.
WARNING:
Except in case of emergency, Klipsch recommends you
do not use these headphones or headsets (headphones
plus microphone) as aviation communication
equipment as they are not engineered for many
environmental conditions common in commercial or
non-commercial aircraft (including, but not limited to:
altitude, temperature, noise conditions, unpressurized
aircraft, etc.) resulting in possible interference to
critical communications.
The Occupational Safety Health Administration (OSHA)
has issued headphone usage recommendations for
maximum daily exposure and sound pressure levels
(measured in decibels (dB)). A decibel is a unit of
measure of sound, and decibels increase exponentially
as sound gets louder. For example, conversational
speech is typically around 60dB, and a rock concert in
a stadium is often about 110dB.
FCC AND CANADA EMC COMPLIANCE INFORMATION
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.