Publicidad
Idiomas disponibles
Idiomas disponibles
Curtains textiles(lowest setting)
Upholstery cushions(sofa,high
class carpets, rugs and runners)
Normal carpets
Long-haired carpets
Hard floors (highest setting)
To set the desired power setting, press the
+button(increase
vacuum
button(reduce the vacuum power) several times
until the desired setting lights up on the vacuum
power display.
6. Move the machine: carry the handle at the back of
vacuum. (Fig 8)
7. Cord rewinding: Switch off the vacuum cleaner
with on/off switch button and pull the plug from the
main socket, press the cord rewinding button, the
power cord will be drawn in. (Fig 9)
Maintenance
1. Change the dust bag: when the dust full indicator
turns red or loss of suction is noticed, it is time to
clear the dust bag or replace with a new bag. (Fig 10)
• Open the front cover by clipping. (Fig 11)
• Take out the bag holder then remove the full dust
bag. (Fig 12)
Installing the dust bag: insert the dust bag into the
bag holder and then put it in the slot cabinet. (Fig 13)
Note: If the dust bag is not installed, the front cover
can't be closed.
power)
or
the
2. Inlet filter: clean the filter with warm water and
allow to dry fully before placing back into the unit.
(Fig 14)
Replacing the inlet filter: clip down and remove the
inlet cover, remove and replace with a suitable filter.
(Fig 15)
3. Clean the outlet filter: open the outlet cover and
take out the HEPA frame and filter. Wash it and
install it after the filter has fully dried.(Fig 16/17)
–
Warning
The plug must be removed from the power socket
before any maintenance or replacement.
If the power cord is damaged, it must be replaced
by the manufacturer or its service agent or an
appropriately qualified person in order to avoid a
hazard.
Publicidad
