Avtech AVM503 Manual Del Usuario página 7

TYPE3

 Standard package
Installation
Guide
Camera Instructions Wrench CD manual
1
TYPE4

 Standard package
Installation
Guide
Camera Instructions Wrench CD manual
Step1: Separate the dome cover from the camera.
Squeeze two sides of the dome cover as located and indicated in Figure 1, and move it upward to remove.
Note: Leave some space between the screws and wall to hook the bracket later.
Step2: Place the camera to where you want to install, on the ceiling or wall, and mark the points for screws.
Step3: (Optional) When the cable is arranged to walk along the wall, find and cut as indicated in Figure 2 to let the cable out.
Step4: Fix the camera to the ceiling or wall with the supplied screws, and connect the camera to power.
Step5: Pan, tilt and rotate the lens to adjust the position and viewing angle.
To rotate the lens, it's recommended to use the supplied wrench by inserting it to any of the three holes on the lens, as shown in Figure 3.
Note: The rotation angle of the lens is not 360°. When rotating the lens, do not force the lens to rotate when you feel resistance. Also, please leave the focal
length the way it is. The default is already the optimum.
Step6: Replace the dome cover back, and fasten the cover screw as indicated in Figure 4.
Note: Please wipe the inner part of the dome cover against the lens for clear images.
Screws &
wall plugs
Figure 1
3
Step1: Disassemble the camera case into three parts as illustrated in Figure 1.
Step2: Locate where you want to install this camera (wall or ceiling), and drill holes on the wall or ceiling for securing the bracket and routing the cables
(if necessary).
Step3: Attach the bracket to the wall (or ceiling), and make sure the cables are routed and arranged properly in the bracket, as shown in Figure 2.
Step4: Secure the bracket to the wall (or ceiling), as shown in Figure 3.
Base
Screws &
wall plugs
Step5: Slightly adjust the camera lens to where it's supposed to face, and replace Part 1 and Part 2 back, as shown in Figure 4 and Figure 5.
Step6: Hold the camera lens and Part 1, rotate only Part 2 clockwise to the end, and replace the screw removed in Step1 back, as shown in Figure 5.
Part 1
Figure 4
Step7: Power on your camera, and check the viewing angle on the PC. Then, Adjust the position and the viewing angle of the camera, if necessary.
Figure 2
Part 1 Part 2
Where to look
Figure 1
Figure 3 Figure 4
Attach to wall (or ceiling)
Cable routing
Figure 2 Figure 3
Figure 5
320_420_328_428_503_521_311_411_511_401_402_332_532_808_829_839_quick_V1.4