Berner 12V Standard Manual Del Propietário página 37

6.2.2. LED Indicators on the Charger
POWER (green) LED lit: The charger is connected to AC power.
CHARGING (yellow/orange) LED pulsing slowly: The charger is charging the battery inside
the booster or is in maintaining mode.
CHARGING (yellow/orange) LED flashing rapidly: The charger has detected a problem with
the battery. See troubleshooting section for more information.
BAD BATTERY (red) LED lit: The charger has detected a problem with the battery. See
troubleshooting section for more information.
Charging the internal battery using the included wall charger.
6.2.3.
Only use the charger that was included with the booster to charge the internal battery
IMPORTANT
of the booster. Using any other charger or using the included charger for any other
purpose could result in personal injury or property damage.
WARNING WARNING
6.2.5. Never alter the AC cord or plug provided – if it does not fit the outlet, have a proper outlet
installed by a qualified electrician. An improper connection can result in a risk of an
DANGER
electric shock or electrocution.
6.2.6. An extension cord should not be used unless absolutely necessary. Use of an improper
extension cord could result in a risk of fire and electric shock. If an extension cord must
be used, make sure:
- That the pins on the plug of the extension cord are the same number, size and shape
as those of the plug on the charger.
- That the extension cord is properly wired and in good electrical condition.
- That the wire size is large enough for the AC ampere rating of the charger.
Recommended minimum cross-section size for extension cord:
- 30.5 meters long or less – use a 1.0 mm² extension cord.
- Over 30.5 meters long – use a 1.25 mm² extension cord.
Charging
6.2.7.
Make sure that both the charger and booster are placed on a dry, nonflammable surface. To
charge the booster, connect the charger included into the charging port that is located at the
front of booster.
Confirm the AC outlet voltage matches the input voltage of the charger.
1. Connect the charger into the electrical wall outlet and confirm that the Green POWER LED on the
charger turns on.
2. Check that the yellow CHARGING LED in charger starts flashing slowly to indicate that charge process
has started. To know status of the charge, check the percentage shown at the display in booster.
3. When the display in booster shows 100 (%), the internal battery is fully charged and the booster is ready to
use. Complete charging may take up to 24 hours. NOTE: The yellow CHARGING LED on the charge will
remain flashing after display shows 100%, because charger enters automatically into maintaining mode.
4. After charge is complete and the booster is ready for use, disconnect the charger from the AC outlet, and
then disconnect the charger from booster.
7. OPERATING INSTRUCTIONS
7.1. Jump starting a vehicle engine
A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE
WARNING
THE RISK OF A SPARK NEAR THE BATTERY:
1. Turn the vehicle's ignition OFF before making cable connections.
2. Connect the booster to the vehicle's battery as described in section 4.
If you have connected the clamps backward, an audio alarm will sound. DO NOT turn the booster
RISK OF ELECTRIC SHOCK OR FIRE.
6.2.4. This battery charger is for use on a nominal 230V 50 Hz circuit.
The plug must be plugged into an outlet that is properly installed
in accordance with all local codes and ordinances. The plug pins
must fit the receptacle (outlet).
• 35 •
EN