Cleaning And Maintenance - Eldom R101 Manual De Instrucciones

OPERATION
- Before the operation make sure that all the components were assembled properly.
- Plug in the appliance.
- The mixer starts its operation after a proper speed is selected with the switch (2).
By changing its position five different speeds can be obtained.
"TURBO" button (3) is used to achieve immediately the maximum speed corresponding to the position "5" of
the switch (2)
When the appliance is no longer used:
Set the switch (2) in the position "0" and unplug the appliance.
-
Tilt the arm of the stand (5) and remove the dough hooks or beaters by pressing the button (1).
-
Remove the bowl (10).
-
BLENDER OPERATION
Before connecting the blender (8) make sure the appliance is unplugged and the switch (2) is set in the
-
position "0".
Remove the housing (12) in the back part of the body of the mixer (4).
-
- Insert the blender (8) on that position and turn it clockwise, photo 3.
- Plug in the appliance.
The mixer starts its operation after a proper speed is selected with the switch (2).
-
After pressing the "TURBO" button (3) we obtain the maximum speed.
When the appliance is no longer used, set the switch (2) in the position "0" and unplug the appliance.
Disassemble the blender (8) by turning it counter clockwise.
Blender knife is an operating component and is not covered by the warranty.
NOTE
- Observe the maximum time of continuous operation:
Exceeding the operation time and lack of sufficient intervals in the operation of the appliance may
result in the irreversible motor damage which is not covered by the manufacturer's warranty.
- To avoid splashing, adjust the rotation of the mixer to the consistency of the processed
- products.
- When the appliance becomes blocked, unplug it before cleaning.
- Accessories and containers are not adapted for the preparation of hot meals.
- If the appliance slows down while mixing or beating, interrupt the operation and rarefy the mixed or beaten
product, if possible.
- To prevent the overflow of products from the bowl while mixing, do not fill it above 2/3 of its capacity.

CLEANING AND MAINTENANCE

Before cleaning, unplug the appliance. Do not wash the appliance in a dish-washer machine. Do not immerse the
body (4), the arm (5) and the stand (9) in water. Clean these components with a damp cloth or towel.
Do not immerse completely the blender (8) in water. Only the ending with the knife can be immersed. Complete
immersion of the blender (8) may result in the knife seizure and the warranty loss. Do not clean the knife with bare
hands. Use a brush for cleaning.
Other components of the appliance can be washed in warm water with a dishwashing liquid.
Do not clean the appliance with sharp, abrasive cloths or sponges as it may destroy the appliance.
•
10 EN
FOT. 3