Heath Zenith 6103 Manual Del Usuario página 3

COMPLETING INSTALLATION
1. Replace the decorative wall plate. In installa-
tions where the Heath
switch is combined with other switches or
outlets on an expanded box, you will need to
purchase a combination wall plate. Various
combination wall plates are available at home
centers and electrical supply stores.
2. Slide the mode selection switch a couple times
to make sure it moves freely.
Electrical Input ................................................................................................................120V, 60 Hz.
Fluorescent Load ...................................30 Watts minimum, Up to 400 Watts Maximum Rapid Start
Motor Load ...................................................................................................Up to 1/8 HP Maximum
Incandescent ...........................................................................Up to 500 Watts Maximum at 120VAC
On-Time ..................................................................................................................Fixed – 5 Minutes
Coverage ................................ up to 10 ft. (3.5 m) at 110°, up to 20 ft. (6.1 m) in front of the sensor
HeathCo LLC reserves the right to discontinue products and to change specifications at any time
without incurring any obligation to incorporate new features in products previously sold.
598-1349-00
/Zenith motion sensor
®
SPECIFICATIONS
USING MOTION SENSOR
WALL SWITCh
MOdE SELECTION SWITCh
This switch allows you to select one of three modes
of operation: OFF, AUTO, or ON.
OFF: Lights stay off.
AUTO: Lights automatically come on when mo-
tion is detected. The lights will turn off 5 minutes
after motion is no longer detected.
ON: Lights stay on continuously.
3