Beper 2PASP001 Manual De Instrucciones página 10

Rechargeable vacuum cleaner Use Instructions
Description of the appliance Fig.A
1. On/off switch
2. Battery indicator
3. Handle release button
4. Speed switch button
5. Motor
6. Tank opener button
7. Dust tank
8. Metal tube release button
9. Metal tube
10. Motorized brush release button
11. Motorized brush
12. Nozzle with brushes
13. Crevice nozzle
14. Wall support
15. Battery charger
The appliance works in two different ways:
A) As a stick vacuum cleaner simply using the tube and its accessories
B) As a handheld vacuum cleaner simply using the accessories without the tube
Caution: before using make sure you have correctly assembled the appliance and its accessories.
Wall support installation
The product is equipped with a wall support and relative fixing kit. The support only helps to keep the appliance
sturdy when the tube and the brush are inserted. The appliance will not be attached to the support but only
supported.
Be sure to install the wall mount so that the brush rests on the floor.
Caution: before using the product, the battery has to be fully charged.
Do not turn on the product during charging.
Before a new charge, discharge completely the battery.
The charging adapter and the top of the appliance may become hot during the charge: that is normal.
It is suggested not to charge at temperatures below 5 ° C (40 ° F) or above 40 ° C (105 ° F), this may damage
the batteries.
Battery charging
When only one line on the battery indicator flashes (FIG.G), turn off the product and connect the electric plug
of the adapter to a socket and the pin of the cable in the corresponding inlet placed on the back of the battery.
The 3 charging lights will light up in sequence. When the battery will be fully charged, the 3 lines will be light up
at the same time (FIG. H).
4 Hours recharge – 20 minutes autonomy in high speed – 40 minutes autonomy in low speed
The battery can be charged attached to the handle but also disconnected from it. To detach the battery from the
handle press the button place under the pin inlet and pull the battery outwards.
To replace the battery on the handle, insert the front part into the compartment on the handle and press the rear
part downwards.
Accessories
Motorized brush
Suitable for cleaning any type of surface, carpets included.
Insert the brush into the tube or directly to the dust tank by pressing it slightly until you hear a click (FIG. D).
To remove it, press the release button and pull the brush out.
Nozzle with brushes
Suitable for cleaning surfaces and worktops, but also sofas and fabrics. To connect and disconnect it, follow the
same instructions of the brush (FIG. F).
10