Features; Control Panel; Charging The Internal Battery - Schumacher Electric SL1316 Manual Del Usuario

5. FEATURES

5
4
3
2
1

6. CONTROL PANEL

DIGITAL DISPLAY
When the clamps are connected to a
vehicle's battery, the digital display indicates
the battery's voltage. When not connected
to a battery, the digital display is used to
indicate the percent of charge of the jump
starter's internal battery. See Display
Messages for a complete list of messages.
NOTE: If the vehicle's battery voltage is
too low to detect, the display will remain
blank; the voltage will not display. A manual
start procedure is required to enable
the jump start function. See Section 8.2,
Starting a Battery with Low Voltage.
NOTE: During charging, the display will
go into sleep mode and will not display
any messages. To turn the display back
on, press any button.

7. CHARGING THE INTERNAL BATTERY

IMPORTANT! CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 3-6 MONTHS, TO KEEP THE
INTERNAL BATTERY FULLY CHARGED
AND PROLONG BATTERY LIFE.
7.1 To reduce the risk of electric shock,
unplug the unit's wall charger from the
outlet before attempting any maintenance
or cleaning. Simply turning off the controls
will not reduce this risk.
7.2 When charging the internal battery, work
in a well ventilated area and do not restrict
the ventilation in any way.
7
6
11 12
9 10
8
15
16
17
1. Case
2. 12V DC car charger
3. 12V port adaptor
4. USB/Micro USB connector
5. 100V~120V AC wall charger
6. Battery clamp adaptor
7. SL1316
8. Jump Start button
9. Digital display
10. Charging LED indicator
11. 12V/USB button
12. Light button
13. 12V Input socket for recharging
14. Light
15. USB port
13
14
16. 12V DC port
17. Jump starter input socket
LED INDICATOR
• Green LED solid – The internal battery
is charging.
• Green LED flashing – Charging has
aborted.
• Green LED pulsing – The internal
battery is fully charged.
FUNCTION BUTTONS
7.3 CHECKING THE LEVEL OF THE
INTERNAL BATTERY
To check the internal battery's charge
level, make sure the unit is turned OFF,
then press the
display will show the battery's percent of
charge. A fully charged internal battery will
read 100%. Charge the internal battery if
the display shows it is under 100%.
• 6 •
LIGHT – Operates the LED light
12V/USB – Enables the 12V DC
port and the USB port
JUMP START – Enables the jump
start function
or button. The digital